Hydrocyclone is made of an upper cylindrical section and a lower conical section. A vortex finder pipe protruding downward at the top of the upper cylindrical section that is a little bit below the tangential feed section . Fluid from centrifugal pump enters the tangential feed section of the hydrocyclone at high velocity on...

Jet Mud Mixers for drilling muds for mud treatment for foundation engineering   Jet Mud Mixer is used to mix water and bentonite powder and cement powder with water. The mixing principle is done either by impeller or by venturi throttle, in both cases the aim is to generate enough shear to end up in a...

Mud tank system is a combination of complete solid control equipment. It divided into different models, which widely used in oilfield site, HDD site and CBM site. It is convenient transportation and installation. The standard equipments are shale shaker, desander, desilter and centrifuge one by one, additional a mud tank with some sand pumps and...

Mud guns are usually placed about 6 inches (~15 cm) from the tank bottom and typically come with a 360° swivel that allows directional positioning to stir dead spots. Dead spots can occur in right-angle compartments that have inadequate mechanical agitation or can be caused by piping or other mechanical obstructions. TR’s premium quality...

Shear pump is a special purpose equipment of quickly preparing and treating the drilled fluid. It can largely quicken the dispersion of clay particles, enlarge the surface area of clay particles and meet customers’ requirements of preparing and treating the high property mud, making the mud obtain the good rheological properties and cutting...

The centrifugal pump is design for handling drilling fluids. This pump plays an important role for drilling muds transfer in solid control system. Such as ,the drillings from mud tank to shale shaker, the pump is the connection as bridge. As the object is drilling mud from deep ground ,our pump is designed for anti-abrasive, anti-corrosive with a...

The Mud Gas Separator is primarily used to separate and safely vent large pockets of free gas, including H2S. It is ideal for use where drilling is likely to en-counter large volumes of gas, sour gas or when an operator is drilling with an underbalanced mud column. The Land Mud/Gas Separator is a field proven and extremely reliable piece of...

    Centrifuges are used to process unweighted and weighted, water-based and oil-based drilling fluids (muds). Mechanical energy is utilized to increase the gravitational force exerted on solids that are present in the mud system. Centrifuges are able to apply over 3,000 G-forces on the liquid/solids mixture, which separates the...

TR Solid Control uses an impeller to mix and suspend the solids using both axial and radial flows, and by utilizing low shear mixers to suspend and mix mud additives particle size degradation and polymer shear. Unlike centrifugal pumps or mud guns. The TR Mud Agitator is relatively low shear and low energy device, so it’s easy to operate...

    Desanders are the second phase of drilling fluids process. Includes two 12-in.(305-mm) diameter polyurethane hydroclones slant mounted over the shaker. Each desander clone includes four replaceable wear resistant polyurethane sections that are joined together with quick release stainless steel clamps. Thedesander is furnished...